Your basket is currently empty!
SenSlip* Fitting Guide (Instructions)
The SenSlip* package is reusable and suitable for storage. To begin, ensure you are clean, dry, and have talcum powder ready.
If this is your first time using the SenSlip* undergarment, take extra time to ensure optimal comfort.
When worn correctly, the SenSlip* should provide maximum comfort. It is a tube made from pre-vulcanized latex. Once fitted, the tube forms a double layer over the glans. These layers are breathable. The SenSlip* has an ‘upside’ or ‘front’ and an ‘underside’ or ‘back.’
To identify this, look for a small bridge at the narrowest point molded into the product. This is on the underside or back of the SenSlip* and will cover the underside of the glans when fitted. The upside or front has a slightly longer length at the ribbed end to cover the base of the flaccid penis. Use talcum powder with the SenSlip* to gently stretch open the section to fit over the glans and pull it to cover entirely. The main body of the SenSlip* should now hang forward of the penis. Roll or pull it back gently so that the surface contacts the shaft. This may take a few attempts but will become second nature.
The glans should now be covered with the double layer of the SenSlip* undergarment. Take your time to get it right. You may need to adjust the ‘overhang’ or length of the SenSlip* to fit properly.
It is recommended not to make adjustments immediately but to wait until you are more familiar with the feel of the product. When ready to adjust the length, use a sharp pair of scissors to follow the pattern at the ribbed end for the correct length. Initially, wear the SenSlip* for just a few hours a day. As you get accustomed, you may want to wear it all day.
The SenSlip* should fit snugly but not too tight. It is designed to stay on the penis all day. You may need to make minor adjustments while using the bathroom.
Caring for Your SenSlip*
To maximize the benefits of your SenSlip* undergarment, please note these important points:
1) Wear the SenSlip* only during conscious hours. Do not wear it while asleep.
2) The SenSlip* is flexible enough to accommodate an erection. If discomfort occurs, remove it immediately.
3) Do not wear the SenSlip* in water. Remove it before bathing or water sports. If it gets wet, remove it, allow it to dry, and use talcum powder to keep it soft.
4) The SenSlip* is not designed as a sexual aid. Using it as such may cause damage.
5) Hand wash the SenSlip* in warm water with a small amount of detergent. Rinse and dry in a warm place overnight. Use talcum powder to soften when dry.
6) Avoid overstretching the SenSlip* when fitting or removing. Handle it with care to extend its life. Do not let it come into contact with oil-based lubricants or ointments.
7) Do not use the SenSlip* if you have open wounds or sores. Never insert it into any part of the body.
8) Avoid oil-based lubricants. Silicon lubricants are safe. Remember, oil-based lubricants will rapidly damage the SenSlip*.


A circumcised penis with the SenSlip Product fitted.